Professional Ethernet network tester
LINK LAN
Measure the cable. Identify the port.
Length, PoE, port matching and correct crimping: LINK LAN brings network diagnostics together in one instrument.
Five checks. One tester.
From cable to switch, without guesswork.
Every function addresses a real structured-cabling task: measuring the run, checking power, finding the port and diagnosing the connector.
Cable length
Measures installed Ethernet cable runs, with user calibration and selectable measurement units.
PoE test
Displays the supply voltage and identifies the IEEE 802.3af, at or bt protocol in use.
Port identification
Identifies the hub or switch Ethernet port that corresponds to the connected cable run.
Port LED
Flashes the corresponding switch-port LED so it can be found immediately in the network cabinet.
Crimping check
Checks conductor mapping and reports split pairs, reversed wires, open circuits and shorts.
Cabling test
Every wire in the right place.
Wire mapping makes time-consuming faults clear: split pairs, reversals, interruptions and short circuits.
Port Flash
One port. No doubt.
Connect LINK LAN to the Ethernet outlet and the corresponding LED flashes on the central switch or hub.Technical specifications
The essential data. All together.
Display
2.4" colour LCD
Cables
CAT5 / CAT6 · UTP and STP
Continuity
Range up to 600 m
Length
5 to 300 m
PoE
DC 5–60 V · IEEE 802.3af / at / bt
PoE load test
2 to 80 W
Battery
3.7 V lithium · 1500 mAh · USB-C
Input protection
DC 60 V
Auto power-off
15 / 30 / 60 min / OFF
Tester dimensions
138.5 × 76 × 30 mm
Remote dimensions
65 × 37 × 23 mm
Remote units
Test cabling from the far end.
The two supplied Remote 1 and 2 units simplify RJ45 run mapping and verification.Included
Ready to get on the network.
- 01Carrying bag
- 02Two Remote 1 and 2 units
- 03LAN cable
- 04USB-C charging cable
- 05User manual